KFL Tooling
Kingdom Forged Labs

Sensor mounting

Mounts that key into the T-slot, so a sensor goes back where it was after a swap. Every size comes from the same tested design.

  • Prox sensor mount, straight

    KFLT-PM-1515-M12-14

    Holds a threaded prox in line with the extrusion. The key drops into the T-slot so the sensor goes back to the same spot every time it's swapped.

    Fits
    1515 or 1010 T-slot
    Sensors
    M8, M12, M18, M30
    Hardware
    1/4-20 or 5/16-18, counterbored
    Material
    PA612-CF15

    Need another size, more than 50, or a PO invoice? Request a quote.

  • Prox sensor mount, 90°

    KFLT-PM90-1515-M12-14

    Points the sensor across the extrusion instead of along it. Gusseted upright, no flex when the cable gets pulled.

    Fits
    1515 or 1010 T-slot
    Sensors
    M8, M12, M18, M30
    Hardware
    1/4-20 or 5/16-18, counterbored
    Material
    PA612-CF15

    Need another size, more than 50, or a PO invoice? Request a quote.

  • Indexed swivel prox mount

    KFLT-PMS-1515-M12-14

    Two pieces. The arm locks into the base at 0, 90, 180 or 270 degrees with one center bolt, so you can re-aim a sensor without re-drilling anything.

    Fits
    1515 T-slot
    Sensors
    M8, M12, M18
    Hardware
    1/4-20 or 5/16-18
    Material
    PA612-CF15

    Need another size, more than 50, or a PO invoice? Request a quote.

  • Photoeye guard with tilt bracket

    KFLT-PEG2-5x5x8.5

    Replaces a machined 5" aluminum tube guard. Mounts with 1/4-20 through the floor; the U-bracket slides on 10-32 wall slots for height and pivots ±20° to aim the beam through the window.

    Size
    5" × 5" × 8.5" tall, 4" × 6.5" window
    Sensors
    Small rectangular photoeyes, M3/M4 holes
    Hardware
    10-32 bracket, 1/4-20 mounting
    Material
    Guard PA6-GF, bracket PA612-CF15

    Photoeye guard, 5" × 5" × 8.5"

    Photoeye tilt bracket

    Need another size, more than 50, or a PO invoice? Request a quote.

  • Retro-reflector bracket

    KFLT-RB-1515-14

    Faces across the conveyor at the photoeye. Center and side slots fit single-screw and two-hole reflectors; slide it along the extrusion to align.

    Fits
    1515 T-slot
    Reflectors
    M4/M5 or #10 mounting
    Hardware
    1/4-20
    Material
    PA612-CF15

    Need another size, more than 50, or a PO invoice? Request a quote.

Need a different size, sensor or bolt pattern? Most parts are one change in the model. Ask in your quote request.