KFL Tooling
Kingdom Forged Labs

Fixturing and inspection

Inspection and holding fixtures. These are made to your part, and the ones shown are examples.

  • Go/no-go gauge

    KFLT-GNG-M12

    Checks drilled M12 sensor holes on the floor. The GO end must enter, the NO-GO end must not. Pins are measured and trued before it ships.

    GO / NO-GO
    12.2 mm / 12.9 mm
    Use
    Shop-floor check, not a calibrated gauge
    Other sizes
    Made to your hole or pin
    Material
    PA612-CF15

    Need another size, more than 50, or a PO invoice? Request a quote.

  • Part nest

    KFLT-NEST-M12

    Holds an M12 prox face-up for assembly, test or teach-in, with room for the jam nut and a straight cordset. Dowel holes put it back in the same place on your fixture plate.

    Holds
    M12 sensors; other parts made to order
    Mounting
    2× M5 + 2× 6 mm dowels
    Material
    PA612-CF15

    Need another size, more than 50, or a PO invoice? Request a quote.

Need a different size, sensor or bolt pattern? Most parts are one change in the model. Ask in your quote request.